Kit Assembly - Metra Electronics 95-7345B Instrucciones De Instalación

1. Remove three screws and remove
the vent from the factory radio
panel. (Figure A)
2. Using the supplied #8 x 3/8" pan
head phillips screws, install the
vent to the kits trim panel.
(Figure B)

Kit Assembly

(Figure A)
(Figure B)
95-7345B
1. Mount the radio to the DDIN
Brackets with the screws supplied
with the unit. (Figure A)
2. Locate the factory wiring harness
in the dash. Metra recommends
using the proper mating adapter
from Metra or AXXESS. Re-connect
the negative battery terminal and
test the unit for proper operation.
3. Mount the radio/bracket assembly
into the dash. (Figure B)
4. Snap the radio trim plate over
the radio/bracket assembly and
reassemble dash in reverse order
of disassembly. (Figure C)
3
(Figure A)
(Figure B)
(Figure C)