Led Display Of Functions - Gigaset HX Manual De Instrucciones

Installation
Once registration has been carried out successfully, you can install the Gigaset Repeater wher-
ever you would like to extend the reception range of your handsets. However, you must ensure
that there is a power point at the place of installation and that the left LED remains on constantly
after the device has been switched on.
If the left LED flashes, the Gigaset Repeater is too far away from the base station or reception is
being hindered by thick walls or metal objects for example (e.g. radiators).
When looking for a suitable installation site, a useful guide is a handset which requires a good
connection with the base station at the Gigaset Repeater installation site.
¤
To operate a handset for the
first time in the extended
Gigaset Repeater area,
switch off the handset within
the new reception range of
the Gigaset Repeater, but
outside the reception range
of the base station, and then
switch it back on again.
If you are using more than one Gigaset Repeater in the area of your base station, you
must keep the Gigaset Repeaters at least 10 m apart.
Operation

LED display of functions

Left LED: display registration and operation function
In operation Light off
Constantly on
Flashing
Not yet Flashing twice per second ready for automatic registration
registered
Light off
Right LED: displays the handset traffic via the repeater
In operation Light off
Flashing once every 3 seconds one handset linked via repeater
Flashing twice every 3 seconds two handset linked via repeater
Constantly on
Base station
Router
power supply off
normal link to base station
no link to base station
automatic registration unsuccessful after 5 mins
no traffic
base station not prepared for operation with a
repeater (does not apply to base stations where
Repeater Mode can be switched off and on)
Operation
Extended
reception
15