Reset Repeater; Check The Accessibility Of A Handset Using A Verification Tone; Troubleshooting - Gigaset HX Manual De Instrucciones

Miscellaneous

Reset repeater

If registration was not successful or re-registration has to be carried out for another reason, you
can reset the repeater as follows.
¤
Press repeater button (left LED flashes slowly).
¤
Release repeater button once the left LED flashes quickly (after approximately 10 seconds).
The repeater is ready for registration once again.

Check the accessibility of a handset using a verification tone

The verification tone enables you to establish whether or not the handset is working in the
extended area, see page 15 of the Gigaset Repeater. This tone is audible on the handset every
2.5 seconds as long as a line is allocated.
Proceed as follows:
¤
Repeater: To switch on the verification tone:
Press repeater button until the right LED lights up (after approximately
20 seconds).
¤
To switch off the verification tone again:
Press repeater button again until the right LED goes out (after approximately
20 seconds).
¤
Handset: Allocate line (hold down call answer button).
¤
When you hear the verification tone, you are in the extended reception area.
If you don't hear a verification tone, move towards the repeater with the
handset until you hear it.
Miscellaneous

Troubleshooting

Problem
Left LED flashes continu-
ously when the registration
procedure has been con-
cluded
Left LED flashes continu-
ously at a selected location
Left LED does not light up at
all
16
Cause
No radio connection to
the base station
No radio connection to
the base station
Power supply off
Action
Repeat registration
Select a new location
Check the power point