SPX POWER TEAM SPF25 Instructions De Montage página 4

Assembly and Operating Instructions, Form No. 102481, Back sheet 2 of 3
ASSEMBLY (CONTINUED)
5. Positioning the work bed:
A. Put a small amount of tension on the cable by
cranking the winch up, taking weight off the pins.
This frees the pins in the end of the bolster next to
the winch (or right side of the press). Pull the loose
pins out.
B. Raise the other end of the bolster by pulling slightly
on the handle until the other two pins are free.
C. Crank the winch for either up or down movement of
the work bed. Reassemble the pins.
IMPORTANT: The winch has a special friction brake
for holding the bolster during positioning. The
friction brake is NOT designed to hold during a
pressing operation nor will it hold a work load
during positioning.
25 TON PRESS
1. Remove the adjusting screw from the cylinder mounting plate. Slip the two pins on the mounting plate over the
back lip on the bottom of the upper bolster.
2. Slide the mounting plate to the right side (winch side) of the press until the front roll pin lines up with the notch on
the front of the upper bolster. Raise the plate until the roll pin clears the lip on the bolster and slide the mounting
plate to the left.
3. Install the adjusting screw in the mounting plate again.
4. Disassemble the hose from the cylinder. Plug the cylinder and the end of the hose.
5. Thread the cylinder into the mounting plate. Position the cylinder so the hose fitting on the cylinder points to the
side of the press where the pump is mounted.
WARNING: To help prevent personal injury, the cylinder and mounting plate MUST have maximum
thread engagement to prevent the threads from stripping while the press is under full load.
6. Thread the hose into the fitting on the cylinder again.
CYLINDER ATTACHMENT
Pump
Figure 3
Gauge
Hose
Mounting
Bracket