Cefar Easy Touch™ - Auto Stimulation Mode - DJO CEFAR REHAB X2 Manual De Instrucciones

CEFAR EASY TOUCH™ – AUTO STIMULATION MODE
To provide a pain relieving effect, the level of stimulation should be perceived as a little bit stronger than
the pain intensity. Since the body initially adapts to the set level of stimulation, it is often required to
14
adjust the amplitude a couple of times to reach the optimal level of stimulation. By using CEFAR EASY
TOUCH™ the amplitude is automatically adjusted, and the optimal level is reached after a few minutes
of stimulation.
For NMES the primary aim is to cause a strong but not painful muscular contraction. With CEFAR EASY
TOUCH™ it is easy to reach the correct stimulation level. By using the patient's individual sensory-motor
threshold CEFAR REHAB X2 applies a coefficient to reach the optimal intensity of stimulation.
To use CEFAR EASY TOUCH™:
Follow steps 1–5 in the section STEP-BY-STEP USE .
6. START THE AUTO TEST
Press the AUTO button
and the amplitude increases gradually.
7. FINISH THE AUTO TEST
TENS programs: Press the AUTO button
able.
NMES programs: Press the AUTO button
If you press AUTO too late, or want to start again for any reason, press the AUTO button again to start
over.
8. REPEAT THE AUTO TEST FOR THE OTHER CHANNEL
Repeat steps 6–7 for the other channel.
9. THE STIMULATION STARTS
The program starts after a few seconds, and the amplitude is automatically adjusted to an optimal level
of stimulation.
If the hand switch is connected, you can start using it now.
Even if you are in AUTO stimulation mode, you can increase or decrease the amplitude at any time by
pressing the INCREASE or DECREASE buttons
the automatic amplitude setting is lost.
for the left or right channel. "AUTO" starts flashing on the display,
AUTO AUTO
P S
AUTO AUTO
S
P
AUTO AUTO
S
P
again when the stimulation level feels comfort-
again at the first visible muscle response.
until the stimulation feels pleasant. If doing so,
AUTO AUTO
S
P