Fcc Requirements - DJO CEFAR REHAB X2 Manual De Instrucciones

portable and mobile RF communications equipment and the CEFAR REHAB X2 Electrotherapy System
The CEFAR REHAB X2 Electrotherapy System is intended for use in an electromagnetic environment in which radiated RF
disturbances are controlled. The customer or the user of the CEFAR REHAB X2 Electrotherapy System can help prevent
electromagnetic interference by maintaining a minimum distance between portable and mobile RF communications equipment
(transmitters) and the CEFAR REHAB X2 Electrotherapy System as recommended below, according to the maximum output
Rated maximum output
power of transmitter
P (W)
0,01
0,1
1
10
100
For transmitters rated at a maximum output power not listed above, the recommended separation distance d in metres (m) can
be estimated using the equation applicable to the frequency of the transmitter, where P is the maximum output power rating of
the transmitter in watts (W) according to the transmitter manufacturer.
NOTE 1 At 80 MHz and 800 MHz, the separation distance for the higher frequency range applies
NOTE 2 These guidelines may not apply in all situations. Electromagnetic propagation is affected by absorption and reflection
from structures, objects and people.

FCC REQUIREMENTS

This device complies with Part 15 of the FCC Rules. Operation
is subject to the following 2 conditions:
FCC ID
Contains Transmitter Module IC
Recommended separation distances between
power of the communications equipment.
Separation distance according to frequency of transmitter
150 kHz to 80 MHz 80 MHz to 800 MHz
3,5
d = √P
[ ]
V 1
(where V 1 = 3V) (where E 1 = 3V/m)
0,12
0,38
1,2
3,8
12
Part 15 of the FCC Requirements
• This device may not cause harmful interference
• This device must accept any interference received,
including the interference that may cause undesired
operation.
T9J-RN42
6514A-RN42
d (m)
800 MHz to 2,5 GHz
3,5 7
d = √P d =
[ ] [
E 1 E 1
(where E 1 = 3V/m)
0,12 0,23
0,38 0,73
1,2 2,3
3,8 7,3
12 23
37
√P
]