Load The Discs; Unload The Discs; Set Your Printing Preferences - Rimage Producer 7100N Manual De Instrucciones

Rimage Producer III™ and Producer IIIN™ User Guide

Load the Discs

You can load up to 100 discs in a bin. You can either remove the carousel to load discs or use the procedure below
to place discs in each bin.
1. Open the front door.
2. Press the operator button to rotate the
carousel and place a bin in position to load
discs.
3. After removing all completed discs from the
bin, place up to 100 discs to be recorded in the
bin.
Important! Place the discs with the
recording side facing down.
Tip: You may designate bins 1 through 4
as input, output, reject, or a specific media
type through your software.
4. Repeat steps 2 - 3 until the required bins are
filled.
5. Close the front door.

Unload the Discs

1. Open the front door.
2. Press the operator button to rotate the carousel and place a bin in position to remove discs.
3. Remove the discs from the bin.
4. Repeat steps 2 - 3 until the required bins are empty.
5. Close the front door.

Set Your Printing Preferences

Printing preferences allow you to set up and run your Producer III autoloader to produce the best possible label on
your discs. Refer to your Printer User Guide for specific printing preferences instructions.
12
All manuals and user guides at all-guides.com
2000538_B