Maintain The Producer Iii Autoloader; Preventative Maintenance Schedule - Rimage Producer 7100N Manual De Instrucciones

Maintain the Producer III Autoloader

This section provides information about preventative maintenance and how to align the printer.

Preventative Maintenance Schedule

Use the following table as a guideline for how often to perform preventative maintenance tasks.
Note: Your system may require more frequent maintenance if used in a dusty area, such as a store or
warehouse.
Before you begin:
1. Power off the Producer III.
2. Disconnect the power cord.
Tool
Lint-free cloth
Non-abbrasive, all-
purpose cleaner
Lint-free cloth
Non-abbrasive, all-
purpose cleaner
Can of compressed air
Vacuum
Can of compressed air
Torx T25 driver
2000538_B
All manuals and user guides at all-guides.com
Task
Align the printer
Refer to the procedures below for more
information.
Wipe down the lead screw and pay
close attention to:
• the area just above the bearing at the
base of the lead screw
• the area just above the lift arm
Wipe down all surfaces of the
autoloader, including:
• sides and top
• Input bins
• output trays
• output bin
• base (remove the input bin first)
• top surface on the lift arm
Remove dust and debris from the fans
at the back of the autoloader.
Remove dust and debris from the
openings at the back of the autoloader.
Remove the side panels and remove all
dust from the embedded PC.
Align the printer. Refer to the
Printer instructions on page 16.
Maintain the Producer III Autoloader
Frequency
Upon installation or if the discs are
not picked correctly from the printer
tray.
Weekly
Weekly
Monthly
Monthly
Monthly
On installation and as needed.
Align the
13