Installation - Klarstein 10035064 Manual Del Usuario

EN

INSTALLATION

Installation instructions
If you have a tool, you can install the device according to the procedure described in
the operating instructions. It is also possible to ask the seller, his service department or a
similarly qualified electrical installation company to install the equipment.
Step 1
Before installing the unit as shown in the figure below, use the installation positioning
cardboard box A1 with holes to mark the installation position on the wall (the wall must
be able to support the weight of the unit). When applying the mark, the horizontal side
of the cardboard must be parallel to the floor. In the position with the mark, drill four
holes with a 10 mm hole and a depth of no less than 70 mm. Make sure that the hole is
perpendicular to the wall. Make sure that the lateral distance and the vertical distance
between two holes are as shown in the figure below:
A A1
18