Revell Control Eru24490 ca Manual De Instrucciones página 7

4 CHARGING THE VEHICLE BATTERY
Attention: The battery and motor must cool down for about 15–30 minutes before
charging and after operating the vehicle. Otherwise they can be damaged. Otherwise
they can be damaged. The charging process must be constantly monitored. Always
ensure that the charging process takes place on a fireproof surface in a fire-resistant
environment.
4A Connect the charger to the battery and plug the charger into a socket. The status
LED on the charger will light up red when charging begins. The colour of the LED on
the charger changes from red to green when the charging process is finished. Discon-
nect the battery from the charger and then unplug the charger from the socket.
4B Replace the battery in the vehicle, plug it in and screw the battery cover back into
place.
After a charge time of approx. 180 minutes, the vehicle can drive for around 20 minutes,
depending on the driving style. If the battery is empty, the car stops in order to prevent a
harmful total discharge of the battery.
Warning notice: If changes to the surface of the battery begin to appear, immediately
discontinue the charging process!
5 START PREPARATION
• Set the ON/OFF switch on the remote
control 2C to the "ON" position 5A. The
power LED 2B on the remote control
flashes.
• Set the ON/OFF switch on the model
1D to the ON position 5B.
The ON/OFF switch on the model and the
remote control must be set to OFF after
use. Otherwise, a drive command can
accidentally be triggered, causing the
vehicle to drive away on its own, which
can lead to considerable damage.
7 VEHICLE CONTROL
7A To drive forwards, pull the lever for forward and reverse travel 2A with the left
index finger.
7B To drive in reverse, push the lever for forward and reverse travel 2A forwards with
the left index finger.
7C To drive along a left curve, turn the steering wheel 2D to the left (top view).
7D To drive along a right curve, turn the steering wheel 2D to the right.
12
6 STEERING TRIM ADJUSTMENT
The correct trim is a basic requirement
for fault-free driving behaviour from the
vehicle. Adjusting the trim is easy, but it
requires a little patience and a feel for it.
Please follow the following instructions
precisely:
If the vehicle pulls to the left or the
right without being steered...
use the straight-ahead trimming 1E to
correct the wheel alignment by turning it in
the opposite direction. The wheel alignment
can be found on the bottom of the vehicle
(cf. 6).
INSTRUCTIONS FOR SAFE DRIVING
GENERAL DRIVING TIPS:
• Always maintain visual contact with the vehicle and do not look at the remote
control!
• On initial driving attempts, there is a general tendency toward excessive movements
of the controls. Make sure that you have sufficient room.
After a crash, always release the lever for forwards and reverse travel immediately in
order to prevent damage to the electronics.
THE SUITABLE DRIVING ENVIRONMENT:
The location in which the vehicle is driven should fulfill the following criteria:
1. It should be a location in which there is as much open area as possible, without
disruptive obstacles.
2. Make absolutely sure when starting that there are no people or animals in the
immediate vicinity.
3. Always watch the vehicle so that it does not drive into the operator, other people or
animals and injuries them.
TROUBLESHOOTING
Problem: The vehicle does not move.
Cause: • The battery is too weak or depleted.
Remedy: • Please charge the battery.
Problem: Remote control does not work.
Cause: 1. The batteries were not inserted correctly.
2. The batteries do not have enough power.
Remedy: 1. Check whether the batteries are inserted correctly.
2. Please replace with new batteries.
Problem: The vehicle cannot be controlled with the remote control.
Cause: 1. The battery in the model or the batteries in the remote control are depleted.
2. The connection between the remote control and vehicle has been severed.
Remedy: 1. Charge the battery in the model or insert new batteries in the remote control.
2. When the model is further than 10 metres away, move towards the model.
Additional tips and trick can be found online at www.revell-control.de.
SERVICE NOTES
Go to www.revell-control.de for ordering information
and tips on replacing spare parts, plus other useful
information on all Revell Control models.
www.revell-control.de
13