Fan Assembly. Pgs - Craftmade Mesmerize Guia De Instalacion

5. Fan Assembly.
Loosen yoke set screws and nuts at top of motor
housing. Remove pin and clip from motor housing
yoke. [Refer to diagram 1.]
Tip: To prepare for threading electrical wires
through downrod, apply a small piece of electrical
tape to the ends of the electrical wires--this will
keep the wires together when threading them
through the downrod. [Refer to diagram 1.]
Thread safety cable and electrical wires through end
of downrod and pull extra wire slack from the upper
end of the downrod. [Refer to diagram 1.]
Thread downrod into the motor housing yoke until
holes for pin and clip in downrod align with holes in
yoke--make sure wires do not get twisted. Re-insert
pin and clip that were previously removed. Tighten
yoke set screws and nuts securely.
[Refer to diagram 2.]
Slide yoke cover over downrod. [Refer to diagram 2.]
["Fan Assembly" continued on next page.]
NOTE: The important safety precautions and
instructions appearing in the manual are not meant
to cover all possible conditions and situations that
may occur. It must be understood that common sense
and caution are necessary factors in the installation
and operation of this fan.
electrical wiring
downrod
clip
diagram 1
yoke
cover
clip
diagram 2
page 5
safety cable
yoke set screw
and nut
pin
motor
housing
downrod
pin
motor
housing