Kohler K–2326 Guia De Instalacion página 5

Hanger
Bolts
Mark
Anchoring
Holes
Apply
Adhesive
Pedestal and Lavatory Placement
Gaskets
2. Install the Lavatory
Drill 1/4" mounting holes at the marked locations on the finished
wall and the floor.
NOTE: You can also use other fastening devices of sufficient size
and strength.
Install the hanger bolts in the wall and floor so they extend
1-3/8" (3.5cm) beyond the finished wall and 1" (2.5cm) beyond
the finished floor.
Install the faucet and drain to the lavatory according to the
manufacturer's instructions.
Lift the pedestal over the hanger bolt in the floor. The hanger bolt
will prevent the pedestal from shifting out of place. There is no
need to secure the pedestal to the hanger bolt with a nut.
Carefully set the lavatory on the pedestal so the hanger bolts
extend through the lavatory anchoring holes.
CAUTION: Risk of product damage. Do not overtighten the cap
nuts. Overtightening may damage the product.
Install the washers and cap nuts to the hanger bolts. Level the
lavatory, and carefully tighten the cap nuts until snug.
Kohler Co.
Install Faucet
and Drain
Finished
Pedestal
Wall
5
Washer
Cap Nut
Mark Floor
Here
1016769-2-B