HAMPTON BAY PORTSMOUTH 51355 Guía De Uso Y Mantenimiento página 7

Assembly - Standard Ceiling Mount
1
Preparing for standard mounting
□
Remove the canopy ring (K) from the canopy (C) by turning
the ring to the right until it unlocks.
□
Remove the mounting bracket (A) from the canopy (C) by
loosening the four screws (SS) on the top of the canopy (C).
□
Remove the two non-slotted screws, and loosen the slotted
screws. This will enable you to remove the mounting bracket
(A).
3
Assembling the fan
WARNING: Failure to properly install the locking pin could
result in the fan becoming loose and possibly falling.
□
Loosen, but do not remove, the setscrew (JJ) on the collar
(M) on top of the motor housing (D).
□
Align the holes at the bottom of the downrod (B) with the
holes in the collar (M) on top of the motor housing (D).
□
Carefully insert the hanger pin (CC) through the holes in the
collar (M) and downrod (B). Be careful not to jam the hanger
pin (DD) against the wiring inside the downrod (B).
□
Insert the locking pin (DD) through the hole near the end of
the hanger pin (CC) until it snaps into its locked position.
□
Re-tighten the setscrew (JJ) on the collar (M) on top of the
motor housing (D).
2
Routing the wires
□
Route the wires exiting the top of the fan motor (D) into the
decorative motor collar cover (F) and through the canopy
ring (K).
□
Make sure the slot openings are on top and route the wires
through the canopy (C) and then through the ball/downrod
assembly (B).
A
SS
C
K
CC
7
Please contact 1-877-527-0313 for further assistance.
C
K
B
F
D
C
B
F
DD
B
M
JJ
D
HAMPTONBAY.COM