Plantronics CA20 Manual Del Usuario página 7

IMPORTANT
IMPORTANT – PLEASE READ BEFORE YOU START INSTALLATION
To ensure maximum performance, please observe the following:
1 Ensure that the base unit (B) is placed at least 30cm (12 inches) away from any computer
monitor, or any other electronic equipment. This includes monitors in close proximity which
may be hidden by office partitions or screens.
2 Ensure that there is at least 15cm (6 inches) separation between the CA20 Adapter
base unit (B) and the telephone.
3 Ensure that there is at least 45cm (18 inches) separation between the CA20 Adapter
base units.
If you experience difficulties during the installation process, contact the Plantronics Customer
Helpline on 0800 410014.
BEFORE YOU BEGIN – PREPARING THE BASE UNIT
(Fig. 1) Connect the telephone handset (A) to the Base Unit as shown. Connect the Base Unit (B)
and AC Adapter (C) cables. Plug the AC Adapter into a local power supply.
Check that all connections have been made correctly.
INSTRUCTIONS
PREPARING THE REMOTE PACK
(Fig. 2)
1 Connect the battery lead and place the battery pack into the remote.
2 Replace the battery compartment cover.
3 Insert the remote pack into the base unit charging cradle bay (8) and charge for 1 hour
before first use.
4 To ensure battery pack is charging correctly, check to see that the charge light on the
base is flashing (9).
Charge for a minimum of 1 hour before first use.
When charged:
1 When the remote is fully charged, the charge light (9) on the base stops flashing and
is fully illuminated.
5