Uline H -7241 Manual Del Usuario página 9

OPERATING ISSUE
No power to machine
No display after power on
Display shown but machine will not start.
Bad film seal
Film seal is stretched.
Film does not run through.
Air cushions do not hold air.
Film jams occur frequently.
Film blockage
Film winding around rollers
PAGE 9 OF 27
TROUBLESHOOTING
Check power cord is connected to both machine and outlet.
Check main power switch is on.
Check power fuse.
Check power fuse.
Contact Uline Customer Service at 1-800-295-5510.
Check film type selection.
Turn off machine, check belt/blade position.
Check sealing units are closed and locked.
Check if film roll shaft is in the right position.
Replace belts and blades.
Adjust the temperature.
Check film type selection.
Check if film roll shaft is in the right position.
Adjust the temperature.
Adjust the air flow.
Check if film roll shaft is jammed.
Check if sealing units are closed and locked.
Check blade placement.
Replace belts and blades.
Film roll is loaded the wrong way.
Check belt/blade position.
Check if film roll shaft is in the right position.
Check if sealing units are closed and locked.
Check film causing blockage.
Check belts and blades. Replace as needed.
Check film and mandrel settings.
Remove and reload film into machine to ensure film is not
jamming up injector.
Check if film roll shaft is jammed.
Remove any film causing blockage.
Check film run on machine.
Remove any film causing blockage.
1-800-295-5510
uline.ca
RECOMMENDATIONS
0621 IH-7241