Fitting The Battery; Control Panel And Display; Control Panel; Switching On/Off - Bosch Drive Unit Speed Manual Original

› Damaged batteries may neither be charged, nor
continue to be used.
› The battery may heat up during charging.
A maximum temperature of 45°C may be
reached. If the battery becomes any warmer than
this, suspend the charging process immediately.
4.4

Fitting the battery

1. Insert the battery into the battery holder of the Pe-
delec from the front/above. At the same time, the key
must be in the lock and must be turned anticlockwise.
Installing the battery
2. Press the battery down into the holder until the lock-
ing mechanism engages. Now turn the key clockwise
and remove it. The battery is now locked in place.
Locking the battery
3. Make sure the battery is firmly in place.

5 Control panel and display

The Xion Pedelec can be controlled via two elements. The
display is located in the middle of the handlebar. The con-
trol panel can be found on the handlebar grip.
Control panel and display
5.1

Control panel

1
2
3
1 Upper arrow button
2 Diamond button
3 Lower arrow button
The three buttons each have different functions depending
on the item of the settings menu in which you are located.

5.1.1 Switching on/off

Press the diamond button to switch the Xion system on.
After a few seconds, the welcome screen appears, followed
by the start menu.
From there you can carry out further settings (➠ Chapter
5.4 "Programming and settings").
VIII User Manual Pedelec Xion 13