INSTRUCTIONS FOR USE
To reduce the risk of electric shock, this appliance is equipped with a polarized plug (one blade
wider than the other). This plug will fit in a polarized outlet only one way. If the plug does not fit
fully in the outlet, reverse the plug. It it still does not fit, contact a qualified electrician to install
the proper outlet. Do not change the plug in any way.
1. Insert the power cord into a 120 volt AC outlet.
2. To activate the Shiatsu massage action, press power
3. To activate the vibration massage, press the power
4. To activate Shiatsu and Vibration massage together, press the power
activate soothing heat with the massage, press the heat
(Figure 2). Allow a few moments for the heating action to warm up.
5. When finished press the power
button again to turn off the massage and heat function and
unplug the pillow.
Figure 1
Caution: To avoid pinching do not lean on the back massage mechanism in the cushion
when adjusting your body position. Don not Jam or force any part of your body in the moving
massage mechanism
button once (Figure 1).
button a second time.
button a third time. To
button. Massage heads will glow red
Figure 2
4
MAINTENANCE
TO STORE
Place massager in its box or in a safe, dry, cool place. Avoid contact with sharp edges or pointed
objects which might cut or puncture the fabric surface. To avoid breakage, do not wrap the
powercord around the unit. Do not hang the unit by the power cord.
TO CLEAN
Unplug the unit and allow it to cool before cleaning. Spot clean only with a soft, slightly damp
sponge. Never allow water or any other liquids to come into contact with the unit.
• DO NOT immerse in any liquid to clean.
• Never use abrasive cleaners, brushes, gasoline, kerosene, glass / furniture polish or paint
thinner to clean.
• DO NOT attempt to repair the Massage Cushion. There are no user serviceable parts. For service,
call the Consumer Relations telephone number listed in the warranty section.
• For service, call the Consumer Relations telephone number listed in the warranty section.
NOTE: Only gentle force should be exerted against the unit in order to eliminate any/all risk of injury.
5