Depth Regulator Lever; Belt Tension Adjustment - MADER HHGT-001B Manual Del Usuario

Depth Regulator Lever

Tilling depth is controlled by the height of the depth regulator lever.
To adjust the tilling depth:
1. Remove the detent pin.
2. Raise the depth regulator lever to position the tines at a chosen tilling depth.
3. Align the hole in depth regulator lever with the hole in the depth regulator bracket and
replace the detent pin.
Depth Regulator Lever Down = Shallower tilling.
Place the detent pin in the top hole of the depth regulator lever for shallowest tilling.
Depth Regulator Lever Up = Deeper tilling.
Place the detent pin in the bottom hole of the depth regulator lever for deepest tilling.
WARNING!
Do not adjust tilling depth unless drive safety control levers are released to neutral
position.
Always set the depth regulator lever in the transport position before starting
engine, that is, place the detent pin in the highest hole of the depth regulator lever.

Belt Tension Adjustment

Proper belt tension is critical for good performance. After ½ hour of operation, all cables may have to
be adjusted due to initial stretch. Thereafter, check tension after every 2 hours of operation.
To Increase belt tension:
1. Loosen the upper jam nut. Turn the nut up cable in 1/8" increments.
2. Tighten the lower jam nut.
3. Check the adjustment.
This procedure can be repeated until conduit adjustment bolts are fully adjusted. If no more
adjustment can be made, belt may have to be replaced.
81