Clean Tine Axle Shaft; Storage; Preparation For Storage - MADER HHGT-001B Manual Del Usuario

CLEAN TINE AXLE SHAFT

1. Turn off the engine. Engine must be cool.
2. Remove the spark plug wire and secure it from spark plug.
3. Tip the tiller forward. Block the tiller in position so that it rests on the engine mount and the
tines are exposed.
4. Remove all vegetation, string, wire, and other material that may have accumulated on the
axle between the inside set of tines and the seal on the transmission housing.
5. Tip the tiller back to a level position.
6. Replace spark plug wire.

STORAGE

PREPARATION FOR STORAGE

WARNING!
Do not store tiller in an unventilated area where fuel fumes may reach flame,
sparks, pilot lights or an ignited object.
Drain fuel outdoors away from any ignition sources. Use only approved fuel
containers.
Follow the steps below to prepare your tiller for storage. Read your engine manual for detailed
instructions on
preparing the engine for storage.
1. Protect the wheels and axles from rust:
* Remove the lock pin and slide wheel off the hub.
* Coat the axles lightly with axle grease.
* Slide the wheel back on the hub and insert the lock pin.
2. Drain the fuel system completely following the engine manufacturer's instructions or add
fuel stabilizer to prevent fuel from gumming up during extended storage period.
3. While engine is still warm, drain the oil from the engine. Refill with fresh oil of the
recommended grade.
4. Clean external surfaces, engine and cooling fan.
5. Remove spark plug, pour one ounce of SAE 30 oil into spark plug hole.
6. Plug the hole and pull the starter cord slowly to distribute oil evenly in cylinder head area.
7. Reinstall spark plug.
8. Transport unit to a suitable storage location. If you have chosen to use a fuel stabilizer and
have not drained the fuel system, follow all safety instructions storage precautions in this
manual to prevent the possibility of fire from the ignition of gasoline fumes. Remember,
gasoline fumes can travel to distant sources of ignition and can ignite, causing risk of
explosion and fire.
9. If there is any possibility of unauthorized use or tampering, remove the spark plug and store
it in a safe place before storing the tiller unit. Be sure to plug the spark plug hole to prevent
foreign material from entering.
88