Mount Cover Plate - Honeywell Home THP2400A1027 Instrucciones De Instalación

THP2400A1027 COVER PLATE ASSEMBLY
INSTALLATION
When Installing this Product...
1. Read these instructions carefully. Failure to follow them could damage the product or cause a hazardous
condition.
2. Check ratings given in the instructions and on the product to make sure the product is suitable for your
application.
3. Installer must be a trained, experienced service technician.
4. After installation is complete, check out product operation as provided in these instructions.
CAUTION
Electrical Hazard.
Can cause electrical shock or equipment damage.
Disconnect power before beginning installation.

Mount Cover Plate

Mount Cover Plate Directly to Wall (See Fig. 2)
1. Pull the wires through the wire hole on the cover plate and wall plate.
2. Position the cover plate and wall plate on the wall with the arrows pointing up. Level the wall plate for
appearance only.
3. Use a pencil to mark the mounting holes for your thermostat.
4. Remove the cover plate and wall plate from the wall. Drill anchor holes. If your thermostat box contains red
anchors, drill 7/32" holes. If your box contains yellow anchors, drill 3/16" holes. Tap the wall anchors (pro-
vided with the thermostat) into the holes, until the anchor collar touches the wall.
5. Pull the wires through the wire hole on the cover plate and wall plate. Position the cover plate and wall
plate on the wall anchors.
6. Insert the mounting screws (provided with the thermostat: #8 1-1/2" for red anchors and #6 1-1/2" for
yellow anchors) into the wall anchors. Check leveling, if desired, and tighten the mounting screws.
WALL OPENING
WALL ANCHORS (2)
(PROVIDED WITH
THERMOSTAT)
WIRE
Fig. 2. Mount cover plate, wall plate and thermostat directly to wall.
69-2759EFS—03
COVER PLATE
WIRE HOLE
MOUNTING HOLES (2)
WALL PLATE
2
WIRE HOLE
MOUNTING HOLES (2)
MOUNTING SCREWS (2)
(PROVIDED WITH
THERMOSTAT)
THERMOSTAT
M34263