Synchronizing Transmitter / Receiver - lidl HG00783A-TX Manual De Instrucciones

Receiver (see Fig. B):
Transmitter:
The product works on 434 MHz which is a quite common frequency.
To ensure that the function is not influenced by doorbells in the
16 US-EN
320257_silv_Design-Funktuerklingel_content_US.indd 16
Remove the battery compartment cover
receiver.
Remove the used battery, if present.
Insert 3 batteries (1.5 V
Note: Ensure correct polarity. This is indicated in the battery
compartment .
8
Close the battery compartment cover
Remove the name plate from the holder
and remove the rubber cover
11
Remove the used batteries, if present (see fig. C2).
Insert a battery (3 V
marked "+" must face up.
Re-install the rubber cover
on to the back of the product.
Fasten the holder, and place screw
to the back of the product & name plate.
The transmitter battery compartment with the holder must be in-
stalled using the screw
stop using the product.

Synchronizing transmitter / receiver

6
(direct current), type AA).
.
6
12
(see fig. C1).
16
(direct current), type CR 2032). The side
, close the holder
16
of the transmitter back on
15
while in use. If the holder is damaged,
15
from the back of the
by pressing the lock
of the transmitter
12
01.03.19 12:13