Axis Q8414-LVS Guia De Instalacion página 10

AXIS Q8414–LVS Network Camera
Install the camera unit
1. Remove the gaskets from the top- and side holes in the back chassis.
2. Position the back chassis in the corner between the ceiling and the walls. Use a pencil to
make marks for the screws through the top- and side holes.
1
Cable gasket, network
2
Cable gasket, I/O
3
Screw (not included)
4
Washer
5
Gasket
3. Drill holes for the screws in the ceiling and in the walls.
4. Plug the gaskets back it into their holes. The gaskets should fit snugly with no folds
or bends.
5. Remove the network cable gasket from the back hole and route the network cable
through this back hole.
6. If applicable: Remove the I/O cable gasket from the back hole and route the I/O cable
through this back hole.
7. Pull the tab on the cable gasket to open it.
8. Attach the AXIS Connector Guard A on top of the RJ45 network connector. Drag the
network cable gasket along the cable and plug the network cable gasket into its hole.
The gasket should fit snugly with no folds or bends.
9. Remove the AXIS Connector Guard A from the top of the RJ45 network connector.
10