AL-KO AMS2 Instrucciones De Instalación página 12

en
18.Only perform this step for tandem installation.
Mark the white cable plugs of the Mammut drive with a waterproof pen.
1 = Drive front left
2 = Drive front right
1
3
19.Place the Mammut drive at the correct distance from the wheel, and tighten the nuts until finger-tight
(10).
Use the supplied minimum spacer block for checking: 20 x 20 x 35 mm (10-a). Distance between
wheel and Mammut roll: minimum: 20 mm - maximum: 35 mm.
20.Lower the vehicle and check the distances again with the wheel suspension compressed.
Drive housing - wheel: ≥ 20 mm (8-b).
Drive roll - wheel: ≥ 20 mm, < 35 mm (10).
21.Recalibrate if necessary:
Loosen nut M8 (4) slightly.
Lightly strike with a rubber hammer to move the frame terminal to the correct position.
Tighten the M8 nut again.
22.Bring your caravan back to a convenient working height and secure it.
23.Then tighten all bolts to a torque of 86 Nm.
12
2
4
3 = Drive rear left
4 = Drive rear right
AMS2 Mammut
Installation instructions