Publicidad
Brake Control Wiring Harness
INSTALLATION INSTRUCTIONS
Note: This harness has been
designed for use with Valley™
brake controls containing a
pre-wired harness conector
(Fig. 1). For all other brake controls, use
Valley harness part number 30404.
1. Read instructions thoroughly before beginning.
2. Locate the vehicles OEM brake control connector
under the dash (Fig. 2). The
connector will be similar to that
found on the Brake Control Wiring
Harness and designed to mate with
it (Fig. 3). Refer to the vehicles
owners manual for additional
information in locating this
connector.
3. Connect the brake control
wiring harness to the brake control
by plugging the mating connectors
together. Ensure that the locking
tabs are engaged (Fig. 4).
4. Plug the opposite end of the brake control wiring
harness into the vehicle's mating connector located during
Fig. 1
Fig. 1
Fig. 2
Publicidad
