Recommended Installation Tools; Installation Requirements - Glaziar Predator SO2000UV Manual De Uso

3 1/2" Hole Saw for wood or
metal (Recommended)
11/32 Open-End Wrench

Installation Requirements

1. Unit should be installed after the air handler in the HVAC
system.
2. The duct work around the installation area should be
clean and dry to ensure proper adhesion of the gasket
materials and any tape used.
3. An approximate 3.5" (8.89 cm) opening will need to be
cut into the existing duct work to install the unit properly.
Electrical Requirements (120 volts units only)
To use the 120-volt plug, be sure to locate the unit within 6 ft. of a standard 120-volt grounded
outlet. Long term use of an extension cord is not recommended due to safety considerations.
Hardwiring Requirements (All units)
Permanent wiring of the unit into your HVAC system, or installation using a 120volt
plug (not included), should be done by a licensed HVAC installer or electrical
contractor only.
LABELING BEFORE INSTALLING.
For 120-volt units: Black = L1, White = Neutral, Green = Ground
25

RECOMMENDED INSTALLATION TOOLS

Drill/Power Driver
¼" Nut Driver Bilt
INSTALLATION REQUIREMENTS
WARNING: UNIT IS 120 VOLT ONLY. CHECK SPECIFICATIONS ON
Screwdriver
You may also need:
Utility Knife
Min. 8" x 8"
Air Handler
www.glaziar.com / info@glaziar.com
Tin Snips (for metal ductwork)
Max. 6 ft.
120 volt
grounded outlet