Glaziar Predator SO2000UV Manual De Uso página 31

5. Insert (4) 2" Threaded bolts into screw holes at
cornersof mounting plate. Attach (4) toggle
adhesive gasket bolt anchors to
7- Insert (4) toggle bolts into 3/8" holes in duct.
Be sure toggle anchors open after inserting
9-Insert unit into opening. Be sure
the air will pass though the PCO
GLAZIAR cell honeycomb matrix.
11-Plug unit into working power receptacle.
Hard wiringunit into HVAC system should
be done by a licensed HVAC installer or
31
ends of threaded bolts.
electrical contractor only.
Stud
6 - Remove backing from mounting
plate adhesive gasket
8- Center large opening in mounting plate
over 3.5" opening in duct and press
plate to duct. The adhesive gasket will
hold the mounting plate into place.
Tighten toggle bolts -
DO NOT OVERTIGHTEN.
10-Secure the unit to the mounting
plate with (4) #8-32 nuts..
www.glaziar.com / info@glaziar.com