Control Unit And Battery Plug; Keypad - RedMax BHT250PD60 Manual Del Usuario

5.8 Control unit and battery plug

5.8.1 To disassemble the control unit and battery
plug
1. Disconnect the plugs to the front handle from the
To assemble the start inhibitor and
control unit. See
the front handle on page 10 .
2. Remove the screws (A) on the control unit and the
screws (B) on the battery plug. Remove the plug (C)
and lift out the control unit, the battery plug and the
cables from the chassis.
B
B
3. Remove the plugs (D and E) to disconnect the
control unit and the battery plug.
5.8.2 To assemble the control unit and battery plug
Note: Make sure the cables are not damaged and are
set correctly in the chassis.
CAUTION: The cables must hang straight down
from the plugs. Make sure that they are not bent
too much.
580 - 001 - 27.03.2018
A
A
C
E
D
1. Connect plugs (D and E) on the battery plug to the
control unit.
2. Make sure that cables (F) and (G) are red.
3. Put the control unit, battery plug and cables into the
chassis.
4. Connect the plug (C). Attach screws (A) on the
control unit and screws (B) on the battery plug.
Tightening torque 1 ~4 Nm.
B
B
5. Connect the plugs for the front handle to the control
To assemble the start inhibitor and the
unit. See
front handle on page 10 .

5.9 Keypad

5.9.1 To disassemble the keypad
CAUTION: The flat cable to the keypad is very
easily damaged.
E
D
F
G
A
A
C
Repair instructions - 15