Continuity Testing - Tripp-Lite T013-001-POE El Manual Del Propietario

Continuity Testing

Notes:
• Electrified cabling cannot be used when testing
• If LED lights appear weak or if the tester unit has
When testing an uninstalled patch cable,
the Main and Remote testers may remain
connected. When testing installed cable, the
Remote Tester will need to be removed from
the Main Tester. Connect one end of the cable
to the appropriate connector on the Main
Tester and the other end of the cable to the
appropriate connector on the Remote Tester.
If this is the first time using the product, insert
a 9V battery into the Main Tester unit's battery
compartment. After inserting the battery,
initiating testing is as simple as connecting
the desired cable and flipping the unit's On/Off
switch. Turning the switch to the On position
will cause the LEDs to blink fast during testing,
while turning the switch to S will cause LEDs
to blink slow. Otherwise, testing is the same
for both.
16-08-515-933624.indb 3
continuity.
not been used for an extended period, replace
the 9V battery.
3
9/20/2016 9:44:09 AM