Tripp-Lite T013-001-POE El Manual Del Propietario página 5

Continuity Testing
No Connection
When a connection cannot be found between
the connectors of a cable being tested, none
of the Pin LEDs on the Main and Remote
Testers will illuminate. As a result, either the
cable is not plugged into the connector on the
Remote Tester or no intact pin connections are
established from one end of the cable to the
other.
Crossed
If cable wires are crossed—such as in a
crossover cable—the Pin LEDs of any pin(s)
where a connection is found will illuminate to
indicate which pins are crossed.
Short
If there is a short in two or more wires, the Pin
LEDs for the corresponding wires will illuminate
on the Main Tester only.
5
16-08-515-933624.indb 5 9/20/2016 9:44:09 AM