Tripp-Lite T013-001-POE El Manual Del Propietario página 6

PoE Detection and Identification
Note: If LED lights appear weak or if tester has not been
in use for an extended period, replace the 9V battery.
1. If this is the first time using the product,
2. Connect the open end of a LAN cable
3. Turn the Main tester unit switch to the On
4. Possible testing results are shown in the
D1
X
X
X
X
16-08-515-933624.indb 6
insert a 9V battery into the Main Tester
unit's battery compartment.
coming from a PoE source to the Main
Tester unit's PoE port.
position.
table below:
D2 D3 D4 Results
X
X
X X
X
X X X
Receiving Endspan (12/36) power using
the IEEE 802.3af (15.4W PoE) standard
Receiving Endspan (12/36) power using
the IEEE 802.3at (30W PoE+) standard
Receiving Midspan (45/78) power using
the IEEE 802.3af (15.4W PoE) standard
Receiving Midspan (45/78) power using
the IEEE 802.3at (30W PoE+) standard
Receiving both Endspan (12/36) and
Midspan (45/78) power using the IEEE
802.3af (15.4W PoE) standard
Receiving both Endspan (12/36) and
Midspan (45/78) power using the IEEE
802.3at (30W PoE+) standard
6
9/20/2016 9:44:09 AM