Timer Operation - Taurus TAS-2250 Manual Del Usuario

Warning
-Select sleep mode at night.
-If you activate this mode during the
day, the power of the air conditioning
appliance will be reduced.

Timer operation

-When the appliance is working, press
the Timer button to set the timer stop
mode.
-Press the buttons "
the time. Each time you press "
" ", the timer will add or take off half
an hour.
-Press the Timer button again, the
flashing will stop and the timer stop
will be set.
Setting the timer On
-When the appliance is not work, press
the Timer button to set the timer on
mode.
-Press the buttons "
the time. Each time you press " " or
" ", the timer will add or take off half
an hour.
-Press the Timer button, the flashing
will stop and the timer On will be set.
-Cancelling the timer setting:
-If you want to cancel the Timer setting,
press the button again and the time light
will disappear. The timer setting will
be cancelled.
Warning
-The timer stop can only be set when
the appliance is working. The timer
start can only be set when the air
conditioning appliance is not working.
Impossibility of using the remote
control
-If it is impossible to use the remote
control, use the switch to turn the
" or " " to set
" or
" or " " to set
appliance on or off. This switch is on
the indoor unit, under the front cover.
-Press the On/Off button to turn the
appliance on.
-Press the On/Off button again to turn
the appliance off.
Warning
-The function mentioned above must
only be used in the case of breakdown
or loss of the remote control.
Cleaning
-To clean the remote control, use a cloth
dampened with water at less than 40ºC
and dry the surface well.
-To clean the front panel, use a soft
object (a damp cloth or a sponge).
-Use only neutral detergent.
-After cleaning the remote control with
water, check that it is properly dry.
-Do not apply water directly to the air
conditioning appliance, as this could
cause electrical discharges or
breakdowns.
Clean the air filters every fortnight.
-Pull the two tabs upwards to open the
front panel. Gently remove the air filter
in the direction of the arrow. Do not
shake the filter so as not to make dust.
-Clean the surface with a vacuum
cleaner or with water.
-Once it is clean, dry it in the shade.
-Lift the two tabs in the front panel, fit
the filter and close the panel.
Advice for long periods of inactivity
-Turn the appliance on in heating or
dehumidifying mode to eliminate the
humidity inside the equipment.
-Always unplug the cable after turning
off the power supply.