Handheld Remote Control Assembly - Craftmade Forum Guia De Instalacion

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

10. Handheld Remote Control Assembly.

IN ORDER TO USE THE HANDHELD REMOTE CONTROL,
PLEASE CONTINUE WITH SECTION 10 for remote control
assembly instructions. If you have already installed the wall
control but do not wish to use the handheld remote control,
please proceed to Section 11.
Gently pull on remote control cover to separate top and
bottom parts. [Refer to diagram 1.]
In order to use wall control as a handheld remote control,
cut each wire on wall control (that was not previously
used)--use wire cutters to cut off each wire as close to the
wall control as possible. [Refer to diagram 2.]
Install one 12-volt battery (included) in wall control. [Refer
to diagram 2.]
The dimmer switch (labeled DIM and ON/OFF) has been
pre-set to the "OFF" position (ON). If you wish to have
dimming capability, please move the switch to the "ON"
position (DIM). [Refer to diagram 2.]
Attach black faceplate to front of wall control; press
down firmly. [Refer to diagram 3.]
Align holes in wall control with posts located on inside of
TOP part of remote control cover and press together
firmly. Place wall control into BOTTOM part of remote
control cover, aligning posts in top of remote control
cover with post holes in the bottom. [Refer to diagram 3.]
(NOTE: Make sure to align narrower ends of remote
control cover before closing.) Squeeze top and bottom of
remote control cover together until you hear a click at
each end, indicating that the remote control cover has
closed completely.
IMPORTANT: Store the remote control away from excess
heat or humidity. To prevent damage to remote control,
remove the battery if remote control will not be used for
long periods.
CAUTION: "DO NOT DISPOSE OF BATTERIES IN FIRE,
BATTERIES MAY EXPLODE OR LEAK." - When disposing of
household alkaline batteries, it is best to check with your
local and state recycling or household hazardous waste
coordinators concerning the specifics of the program in
your area. You may also locate a recycling center by
calling 1-800-8-BATTERY or 1-877-2-RECYCLE or visit
www.epa.gov/epawaste/index.htm or www.earth911.org
for more information.
WARNING: Choking Hazard - Small parts. Keep battery
away from children.
WARNING: Non-rechargeable batteries are not to be
recharged; Do not mix different types of batteries such as
alkaline, carbon-zinc, or rechargeable batteries; Do not
mix old and new batteries; Batteries are to be inserted
with the correct polarity; Exhausted batteries are to be
removed from the product.
diagram 1
diagram 2
post
hole
remote control
cover, BOTTOM
diagram 3
page 10
remote
control
cover
(top)
(bottom)
wall control
dimmer
wire
switch
DIM ON
wire
wire
12V battery
hole
DIM ON
face-
plate
wall
control
post
remote control
cover, TOP

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Frm52

Tabla de contenido