Black+Decker MTOS4 Manual Del Usuario página 8

ENGLISH
Carbide rasp.
(Part number - X26130-XJ)
Carbide coated surface ideal for grout
removal and for fast stock removal of
plastics, chipboard and fibreglass.
Sanding Sheets.
Various grades for sanding of wood,
painted and varnished surfaces.
Assembly
Warning! Before assembly, remove the battery
from the tool.
Fitting a BLACK+DECKER / Piranha acces-
sory (fig. A)
Hold the tool and squeeze the accessory
u
clamping lever (10).
Slide the accessory (11) between the shaft and
u
the accessory holder making sure the acces-
sory engages all eight pins on the holder and is
flush with the shaft.
Release the accessory clamping lever.
u
Note: Some accessories, such as scrapers and
blades can be mounted at an angle if required.
8
(Original instructions)
Removing a BLACK+DECKER / Piranha
accessory (fig. A)
Hold the tool and squeeze the accessory
u
clamping lever (10).
Pull the accessory from the tool making sure
u
the accessory dis-engages from all eight pins
on the holder.
Release the accessory clamping lever.
u
Warning: Gloves must be worn when removing ac-
cessories as they may become hot during use.
Fitting a sanding sheet (fig. B)
Line up the sanding sheet (12) with the sand-
u
ing base (13) as shown.
Press the sheet firmly and evenly onto the
u
sanding base, making sure that the holes in the
sheet coincide with the holes in the base.
Removing a sanding sheet
Pull the sanding sheet (12) off the sanding
u
base (13).
Warning! Never use the sanding base without a
sanding sheet or accessory in place.
Fitting the dust extraction adaptor (fig. B)
Line up the vacuum adaptor (15) with one end
u
of the tube (14) as shown.
Press the adaptor firmly and evenly in to the
u
tube.