Black+Decker MTOS4 Manual Del Usuario página 9

Line up the tube (14) with the sanding base
u
(13) as shown.
Press the tube firmly and evenly on to the
u
sanding base.
Secure the tube by turning the locking nut (16)
u
clockwise.
Connect a vacuum cleaner to the vacuum
u
adaptor.
Removing the dust extraction adaptor
Turn the locking nut (16) anti-clockwise.
u
Pull the tube(14) out of the sanding base (13).
u
Fitting alternative accessories (fig. C)
Place the spacer (17) onto the collar (18).
u
Place the alternative accessory (19) onto the
u
collar (18).
Firmly attach the fixing bolt (20) into place to
u
ensure a tight fit for the alternative accessory
(19) with the hex key provided.
Note: The spacer and fixing bolt are not used to
attach BLACK+DECKER accessories. Black and
Decker accessories are attached using the Super-
lok Tool free accessory clamping lever.
TM
(Original instructions)
Use
Warning! Let the tool work at its own pace. Do not
overload.
Variable speed control (fig. A)
Note: Ensure the forward reverse slider (2) is not
in the locked position.
To switch the tool on, press the variable speed
u
switch (1). The tool speed depends on how far
you press the switch.
To switch the tool off, release the variable
u
speed switch.
Hints for optimum use
Always hold the tool securely. For precision
u
work, hold the tool near the front.
Clamp the workpiece whenever possible,
u
especially when using cutting blades.
Do not exert too much pressure on the tool.
u
Always use the appropriate type of attachment
u
for the workpiece material and type of cut.
Regularly check the condition of accessories.
u
Replace when necessary.
Mark the desired starting point.
u
Switch the tool on and slowly feed attachments
u
into the workpiece at the desired starting point.
Clamp a piece of plywood or soft wood to the
u
back of the workpiece and saw through the
combination in order to obtain a clear cut.
ENGLISH
9