Installation
1
Removing the strain relief, cover
and hex nut
□ Use a flathead screwdriver (not included) to loosen
and then remove the strain relief (GG) from the wire
(B).
□ Remove the cover (C) from the wire (B).
□ Unscrew the hex nut (D) from the nipple (E).
□ Remove the hex nut (D) from the wire (B).
3
Attaching the mounting bracket to
the outlet box
□ Screw the mounting screws (FF) into the outside holes
of the mounting bracket (AA).
□ Place the mounting bracket (AA) against the outlet
box (not included). Make sure the threads of the
mounting screws (FF) are facing away from the outlet
box.
□ Place the outlet box screws (DD) through the long oval
holes on the mounting bracket (AA), and screw them
into the threaded holes on the outlet box.
2
Assembling the light fixture
□ Pull the wire (B) through the hole in the center of the
shade (G) until the shade (G) is over the nipple (E).
□ Pull the wire (B) through the hex nut (D) until the hex
nut (D) is on top of the nipple (E). Screw the hex nut
(D) onto the nipple (E) to secure the shade (G).
□ Pull the wire (B) through the cover (C) until the cover
(C) is on top of the shade (G).
□ Pull the wire (B) through the canopy (A) and the
strain relief (GG).
5
Please contact 1-855-HD-HAMPTON for further assistance.
HAMPTONBAY.COM