Giordani Citywave Instrucciones página 23

MATERIALS
Outer lining: 100% polyester
Structure:
aluminum
DIMENSIONS
Open: L: 86 cm;
H: 60 cm;
D: 107 cm.
Close:
L: 78.5 cm;
H: 60 cm;
D: 41 cm.
WARNINGS
• WARNING
Never leave the child unattended.
• WARNING Ensure that all the locking devices
are engaged before use.
• WARNING To avoid injury ensure that the child
is kept away when unfolding and folding this
product.
• WARNING
Do not let the child play with this
product.
• WARNING Always use the restraint system .
• WARNING Tenere lontano dal fuoco.
• WARNING Check that the pram body or seat
unit or car seat attachment devices are correct-
ly engaged before use.
• WARNING This product is not suitable for run-
ning or skating.
• WARNING This vehicle is suitable for children
under 3 years old up to 15 kg.
• WARNING
The most reclined position is de-
signed for new born babies.
• WARNING To prevent serious injury always use
seat belt.
• WARNING Parking device shall be engaged
when placing and removing the children.
• WARNING Always set both brakes when stroller
is not being pushed.
• WARNING Pay attention the child's safety when
using the stroller's moving parts (backrest, rain
cover). Always engage the brake when perform-
ing the above operations.
• WARNING Do not leave the vehicle on a slope
when a child is seated in it, even if the brake is
applied. Brake performance is limited on step
gradients.
• WARNING Do not overload the parcel basket (3
kg). Do not carry parcels and accessories any-
where other than in the basket. It makes stroller
unstable.
• WARNING Any load attached to the handle and/
or on the back of the backrest and/or on the sides
of the vehicle will affect the stability of the vehicle.
• WARNING This stroller is to be used for one
child only.
• WARNING Do not use accessories not approved
by the manufacturer. Only replacement parts
supplied or recommended by the manufacturer/
distributor shall be used.
• No additional mattress shall be added unless
recommended by the manufacturer.
• WARNING Don't use stroller on escalators or
stairs while child in it, child could fall out.
• WARNING The child should be clear of moving
parts while making adjustments. Be particularly
careful when performing these tasks with the
child nearby.
• WARNING
Don't allow child to hang on the
stroller.
• Regularly inspect all locking devices to ensure
perfect product maintenance. Do not use the
product if breakages or damage of any kind are
found. In product event contact the Retailer or
the Manufacturer immediately. Keep packaging
materials, such as plastic or waterproof wrap-
pings, away from children to avoid suffocation.
CARRYCOT
HOOD ASSEMBLY
16. Raise the hood axis as shown in Fig. 16a and
insert the 2 side metal plates on the axis.
The metal plate is mounted correctly when
a CLICK is heard. Before using the carrycot,
try moving the hood with your hands to make
sure it is fixedly mounted (see Fig. 16a/16b).
Insert the decorative parts in the base of the
clip as shown in figure 16c. The decorative
clips are mounted correctly when a CLICK is
heard. Before using the carrycot, try moving
them with your hands to make sure each clip
is fixedly mounted. The hood is completely
assembled as shown in Fig. 16d.
FITTING THE LEG COVER
17. As shown in Fig. 17a/17b/17c, first place the
leg cover on the kit, and then attach the snap
button and fasten with THE Velcro.
HOOD ADJUSTMENT
18. Opening the hood: Open the hood by pushing
44
it forward as shown in Fig. 18a.
19. Closing the hood: When storing the carrycot,
close the hood as indicated by the arrow (see
Fig. 19a/19b).
ADJUSTABLE HANDLE
20. Unlocking the handle: Pull the handle upward
as indicated by the arrow, it can be adjusted in
three positions. The carrycot is correctly fixed
when a CLICK is heard (see Fig. 20).
Locking the handle: Press the buttons on both
sides of the handle bar simultaneously and the
adapter will lock, then push it as indicated by
arrow 2. The handle is securely locked when a
CLICK is heard (see Fig. 20a/20b).
ADJUSTABLE BACKREST
21. Turn the knob clockwise, the backrest can be
raised to the highest position at 165°. Turn
the knob counter-clockwise and push down
slightly: this way the backrest can be lowered
(see Fig. 21a/21b/21c).
ACCESSORIES
22. Preparation before use: First mount the large
buckle on the carrycot. Fix "hole a" to the fixed
plastic element b, insert and push the large
buckle at the same time downwards as indicat-
ed by arrow 2 (see Fig. 22a/22b). Repeat the op-
eration also for the other buckle of the carrycot.
23. Pay attention to the various operations when
the seat is used in the car, see Fig. 23a/23b.
24. Fitting the carrycot in the car: Mount the
carrycot in the position shown in Fig. 23a/23b. Insert
the car's security slot into the buckle on the seat and
push out the seat belt (see Fig. 24a/24b); create an
eyelet with the strap, pass the eyelet in the hole of
the metal connector of the car and pass it on the tab
of the connector as indicated in Fig. 24c/24d; tighten
the seat belt as indicated by the arrow (see Fig. 24e).
Repeat the operation also for the other buckle. In this
way the carrycot is permanently mounted in the car as
indicated in Fig. 24f/24g.
25. Removing the carrycot from the car:
As shown in Fig. 25a, the carrycot can be
disassembled from the car by releasing the
large buckle (see arrow). Large buckles can
be fastened to the seat belt after removing
the carrycot from the car (see Fig. 25b).
Note: The carrycot can only be mounted on
the rear seat and always in the direction of
travel. It can be mounted in vehicles equipped
with a 3-point static belt in compliance with
the R6 ECE/EEC standard.
WARNING
26. For safety reasons, never place the child's
head facing the door. Once the carrycot is
mounted in the back seat, for the child's safety
make sure that the carrycot restraint system is
securely fastened, especially if you are travel-
ling. After fitting the carrycot on the back seat,
adjust the backrest to the lowest position and
lower the transport handle. When installed in
the rear seat, the seat belts that hold the car-
rycot's restraint system to the vehicle must be
securely tightened. Adjust the seat belt to its
maximum length to ensure the stability of the
carrycot when used in the car. Adjust the seat
belt to keep the carrycot stable in the vehicle,
the belt must be tight and never twisted.
USE OF SAFETY BELTS IN THE CAR
27. If the carrycot is used as a car seat, press the
centre button to open the buckle, see Fig. 27a.
Connect the buckle to both sides, the buckle
can be fixed, see Fig. 27b.
Note: Always use the seat belt when the child
is in the carrycot.
USE OF SAFETY BELTS OUTSIDE THE CAR
28. When using the carrycot outside the car, the
seat belts must be hidden. Remove the reduc-
er by removing the belt from the eyelets (Fig.
28a). Remove the two ends of the belt from
the mattress by passing the buckles into the
corresponding eyelets (Fig. 28b). Place the
two ends of the belt towards the foot area of
the carrycot (Fig. 28c). Reposition the mat-
tress so as to cover the two ends of the belt.
For use in cars the steps must be repeated in
reverse order to make the belt usable.
USE OF THE BREATHING HOLE
29. Opening the ventilation hole: Turn the knob
under the basket anti-clockwise, the breathing
holes will open. The ventilation function is now
enabled with all the holes facing up.
30. Closing the ventilation hole: Turn the knob
under the basket clockwise, the breathing holes
will close (see Fig. 30a/30b). There will be no
45