WARNING - USE THE CORRECT DOMESTIC GAS REGULATOR. DO NOT USE AN
INDUSTRIAL GAS REGULATOR. DOMESTIC GAS REGULATOR FOR LPG 30mbar.
HOB BURNERS:
REGULATING THE MINIMUM SETTING.
The following procedure is recommended:
ignite the burner and leave it in operation at its rated flow-rate for about 10 minutes;
-
-
then turn the knob to the minimum setting;
remove the knob, pulling it off the tap shaft;
-
use a small screwdriver to regulate the minimum setting, turning clockwise to reduce the
-
flame or anti-clockwise to increase.
In normal taps, the regulating screw for adjusting the minimum setting is inside the rod.
In taps with valve, the regulating screw is on the body of the tap itself.
After any replacement of adjustments, reassemble all parts carefully to restore the original
functions.
OVEN BURNERS
REGULATING THE MINIMUM SETTING (oven burner)
ignite the burner and turn the knob to the maximum temperature;
-
-
allow the oven to warm up for at least 10 minutes;
remove the knob from the thermostat rod and use a small screwdriver to adjust the by-pass
-
screw;
turn clockwise to reduce the flame or anti-clockwise to increase. The flame must be short
-
and stable, must withstand any draughts and closing of the oven door, and must not blow
back.
CHILD SAFETY
• This appliance has been designed for use by adults. Take care, therefore that children do
not attempt to play with it.
• The appliance will become hot during operation and can remain hot for a long time after
being switched off.
• Supervise children and pay attention that they do not touch surfaces or remain in the vicinity
of the appliance when in use or when not completely cooled.
-42-