VONROC HT501DC Traducción Del Manual Original página 8

Ocultar thumbs Ver también para HT501DC:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 36
EN
Model No.
Battery Type
Voltage
Capacity
Recommended charger
Weight
Model No.
Charger input
Charger output
Charging time 2Ah battery
Charging time 4Ah battery
Recommended batteries
Weight
Model No.
Battery Type
Voltage
Capacity
Recommended charger
Weight
Only use the following batteries of the VONROC
VPOWER 20V battery platform. Using any other bat-
teries could cause serious injury or damage the tool.
CD801AA
20V, 2Ah Lithium-Ion
CD803AA
20V, 4Ah Lithium-Ion
The following charger of the can be used to charge
these batteries.
CD802AA
Quick charger
The batteries of the VONROC VPOWER 20V battery
platform are interchangeable with all the VONROC
VPOWER 20V battery platform tools.
Vibration level
The vibration emission level stated in this instruc-
tion manual has been measured in accordance
with a standardized test given in EN60745; it may
be used to compare one tool with another and as
a preliminary assessment of exposure to vibration
when using the tool for the applications mentioned.
8
CD801AA
• Using the tool for different applications, or with
Lithium-Ion
20V
• The times when the tool is switched off or when
2.0 Ah
CD802AA
0.3 kg
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
CD802AA
your hands warm, and organizing your work patterns.
220-240V, 50Hz 0.4A
DESCRIPTION
21V
2.5A
The numbers in the text refer to the diagrams on
page 2-3.
60 minutes
120 minutes
1. On/Off button
CD801AA, CD803AA
2. Battery
3. Battery unlock button
0.36 kg
4. Cutting blade
5. Protection guard
CD803AA
6. Front handle
Lithium-Ion
7. Safety switch
8. Transport protection
20V
9. Battery LED indicators button
4.0 Ah
10. Battery LED indicators
CD802AA
11. Charger
12. Charger LED indicators
0.65 kg
3. ASSEMBLY
Mounting the front handle (Fig. B)
1. Put the front handle (6) on the machine, as
2. Mount the front handle (6) by tightening the
Mounting the protection guard (Fig. C)
1. Put the protection guard (5) on the machine, as
2. Mount the protection guard (5) by tightening
different or poorly maintained accessories, may
significantly increase the exposure level.
it is running but not actually doing the job, may
significantly reduce the exposure level.
Before any work on the power tool, remove
the battery.
The battery must be charged before first
use.
shown on figure B.
four screws.
You may not use the hedge trimmer without
the protection guard.
shown on figure C.
the two screws.
WWW.VONROC.COM

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

S_ht501dcS2_ht501dcS3_ht501dc

Tabla de contenido