VONROC HT501DC Traducción Del Manual Original página 9

Ocultar thumbs Ver también para HT501DC:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 36
Inserting the battery into the machine (Fig. A, D)
Ensure that the exterior of the battery is
clean and dry before connecting to the
charger or machine.
1. Insert the battery (2) into the base of the machine
as shown in Fig. D.
2. Push the battery further forward until it clicks
into place.
Removing the battery from the machine (Fig. A, D)
1. Push the battery unlock button (3).
2. Pull the battery out of the machine like shown
in Fig. D.
Checking the battery charging status (Fig. E)
• To check the battery charge status, push the
button (9) on battery shortly.
• The battery has 3 lights indicating the charge
level, the more lights that burn, the more charge
the battery has left.
• When the lights are not burning it means the bat-
tery is empty and must be charged immediately.
Charging the battery with the charger (Fig. E)
1. Take the battery (2) from the machine.
2. Turn the battery (2) to upside down position and
slide it onto the charger (11) as shown in Fig. E.
3. Push the battery until it is fully pushed into the
slot.
4. Plug the charger plug into an electrical outlet
and wait for a while. The LED indicators (12) on
the charger (11) will lighten up and show the
charger status.
The charger has 2 LED indicators (12) which indicate
the status of the charging process:
Red LED Status
Green LED status
Off
Off
Off
On
On
Off
WWW.VONROC.COM
• Fully charging the 2Ah battery may take up to
60 minutes.
• Fully charging the 4Ah battery may take up to
120 minutes.
After the battery is fully charged remove the charger
plug from the outlet and remove the battery from
the charger.
4. OPERATION
Using your hedge trimmer
• For your own safety and for best results read
the following user advice and do not use this
product for anything other than its intended
purpose.
• This hedge trimmer is made for cutting hedges
and bushes. All other use that is not specifically
allowed in this manual mat lead to manage to
the hedge trimmer or injury to the user.
Switching on and off (Fig. A)
• To switch the trimmer on, press the safety switch
(7) and the start switch (1) at the same time.
Charger status
• To switch off, release one or both switches.
No power
Trimming a hedge ­ best method
Standby mode:
• Apart from hedges the hedge trimmer may also
- No battery is
be used for cutting bushes.
inserted or,
• The best cutting effect is achieved when hol-
- Battery inserted
ding the blade at an angle to the of approx. 15°.
but charging has
• The opposite rotating knives cut on both sides,
finished
and it is therefore possible to trim the hedge in
Battery charging in
both directions.
progress
• The side of the hedge are trimmed using curved
shaped movements from the bottom and upwards.
When the machine is not being used over a
longer period of time it is best to store the
battery in charged condition.
Before using, always visually inspect to
see that the blades, blade bolts and cutter
assembly are not worn or damaged.
You may not use the hedge trimmer
without the protection guard.
Always use both hands to hold the
hedge trimmer and keep it away from
your own body.
EN
9

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

S_ht501dcS2_ht501dcS3_ht501dc

Tabla de contenido