Levolor Roman Shades Instalación página 19

OUTSIDE MOUNT (OM)
STEP 4: MOUNT THE BATTERY WAND INTO THE
BATTERY WAND CLIP
• Align the battery wand with its socket
toward the motor side end cap.
• Push the battery wand straight up into
the battery wand clip until it snaps into
place. Check to make sure the battery wand is secure.
IMPORTANT: Be sure the cable does not become pinched by the battery wand
clip during installation. Damage or overheating of components could result.
STEP 5: PLUG THE POWER CABLE INTO THE BATTERY WAND
• On the back of the headrail, connect the power cable (coming
from the shade) into the socket on the battery wand.
Connect the Power Source
NOTE: When power is connected to the motor, a green LED inside the manual control
button housing will flash to indicate the shade is ready for operation.
Back of Shade
Socket
Battery-Powered Motorized Operating System
INSTALLATION
19