PRODUCT SPECIFICATIONS
Fuel Tank Capacity .................................................................................................................................................... 0.25 gal.
Maximum Pounds Per Square Inch Pressure* ......................................................................................................... 2,200 psi
Maximum Gallons Per Minute* ...................................................................................................................................2.0 gpm
Maximum Inlet Water Temperature ................................................................................................................................104˚F
*Max. rating determined by PWMA Standard 101
KNOW yOUR PRESSURE WASHER
See Figure 1.
The safe use of this product requires an understanding of
the information on the tool and in this operator's manual as
well as a knowledge of the project you are attempting. Before
use of this product, familiarize yourself with all operating
features and safety rules.
AUTOMATIC DETERGENT INJECTION
SySTEM
Place the detergent injection hose with filter into your desired
pressure washer detergent to apply detergent quickly and
easily to your cleaning project. Use of the soap nozzle will
activate the detergent injector at a 20:1 dilution ratio.
FUEL TANK
This fuel tank has a maximum capacity of 0.25 gal. Use
unleaded automotive gasoline in the engine.
HOSE STORAGE
Once the high pressure hose is rolled, hang it on the machine
using the hook-and-loop strap to secure in place.
ON/OFF SWITCH
To turn the engine off, press the ON/OFF switch.
The following tools (not included or drawn to scale) are needed for assembly:
See Figure 1a.
Combination wrench
FEATURES
RECOIL STARTER
The recoil starter is pulled to start the machine.
SOAP NOZZLE
The blue soap nozzle is used to apply detergent at low
pressure only.
THERMAL RELIEF VALVE
This pump feature will prevent water temperatures from
reaching harmful levels by releasing a small amount of
water. Once the water has drained, the thermal relief valve
will reset itself.
NOTE: If the pressure washer is sitting on grass when the
thermal releif valve releases hot water, burn spots on the
grass may occur.
TRIGGER HANDLE
The trigger handle has a gripping surface that provides
added control of the spray wand and helps reduce fatigue.
Both the trigger handle and spray wand have storage areas
located on the sides of the machine.
TRIGGER WITH LOCK OUT
Pulling the trigger releases a stream of water for high
pressure cleaning. The lock out provides protection against
unauthorized use.
TOOLS NEEDED
Page 7 — English