Features; Assembly - Power Stroke PS262311 Manual Del Operador

PRODUCT SPECIFICATIONS
Engine .............................................................................................................................................................Honda GCV160
Fuel Tank Capacity .................................................................................................................................... 0.29 gal (1.1 liters)
Maximum Pounds Per Square Inch Pressure* ......................................................................................................... 2,600 psi
Maximum Gallons Per Minute* ...................................................................................................................................2.3 gpm
Maximum Inlet Water Temperature ................................................................................................................................104˚F
*Max. rating determined by PWMA Standard 101
KNOW yOUR PRESSURE WASHER
See Figure 1, page iii.
The safe use of this product requires an understanding of
the information on the tool and in this operator's manual as
well as a knowledge of the project you are attempting. Before
use of this product, familiarize yourself with all operating
features and safety rules.
ON/STOP SWITCH
The on/stop switch is used in combination with the starter
grip and rope to start the engine. It is also used to turn the
engine off.
FUEL TANK
This fuel tank has a maximum capacity of 0.29 gal.
(1.1 liters). Use unleaded automotive gasoline in the
engine.
HONDA GCV160 ENGINE
This Honda engine enables the pressure washer to achieve
2,600 psi (pounds per square inch) at a rate of 2.3 gpm
(gallons per minute). Please read the engine manual included
with this product.
UNPACKING
This product requires assembly.
 Carefully cut the box down the sides then remove the
tool and any accessories from the box. Make sure that
all items listed in the packing list are included.
WARNING:
Do not use this product if any parts on the packing list
are already assembled to your product when you unpack
it. Parts on this list are not assembled to the product by
the manufacturer and require customer installation. Use
of a product that may have been improperly assembled
could result in serious personal injury.

FEATURES

HOSE STORAGE
Once the high pressure hose is rolled, hang it on the back of
the machine using the stretch strap to secure in place.
STARTER GRIP AND ROPE
The starter grip and rope is pulled to start the machine.
SPARK ARRESTOR
This engine is not factory equipped with a spark arrestor.
In some areas it is illegal to operate an engine without a spark
arrestor. A spark arrestor is available by calling customer
service for assistance.
THERMAL RELIEF VALVE
This pump feature will prevent water temperatures from
reaching harmful levels by releasing a small amount of water
from a rubber hose. Once the water has drained, the thermal
relief valve will reset itself.
TRIGGER HANDLE
The trigger handle has a gripping surface that provides added
control of the spray wand and helps reduce fatigue.
TRIGGER WITH LOCK OUT
Pulling the trigger releases a stream of water for high
pressure cleaning. The lock out provides protection against
unauthorized use.

ASSEMBLy

NOTE: This tool is heavy. To avoid back injury, lift with
your legs, not your back, and get help when needed.
 Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
 Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the tool.
 If any parts are damaged or missing, please call
1-877-617-3501 for assistance.
Page 7 — English