Battery Charging - yellow jacket 52030F Instrucciones De Operación

OPERATING INSTRUCTIONS
1. Pull and release the trigger to capture a
2. If AUTO SAVE is turned ON, the image will
3. If AUTO SAVE is turned OFF, you must save
Note: Images can only be saved if an SD card is installed.
IMAGE VIEWING
thermal image. See the section near the
end of this manual titled AUTO SAVE.
be automatically saved to the SD card
memory.
the image manually. You can save the
image to the SD card memory by pressing
the left arrow button. To discard the
image, press the right arrow button.
Press the SET button to confirm or the
back button to return.
1. Press the blue replay button to enter the picture gallery.
2. Use the up/down/left/right buttons to select the desired image.
3. Press the SET button to view the image in full screen mode.
4. Press the SET button in full screen mode to delete the image or view its
information.
Note: Do not remove or insert the SD card while viewing images
LED LIGHT OPERATION
Press and hold the flashlight button for 3 seconds to turn ON or OFF the
LED light. When the temperature alert is on and the measured temperature
exceeds the set temperature range, the LED light will flash.
Note: When the LED light is on, please do not aim it into the eyes of people
or animals.

BATTERY CHARGING

The thermal imager battery is charged using the supplied USB cable. You
can also connect the USB cable to a 120V AC outlet using the USB cable
and a safety-certified 5V/1A or 5V/2A power adapter (not
included).