Fan Assembly. Pgs - Craftmade Cronus Guia De Instalacion

5. Fan Assembly.
Remove 6 screws and washers from yoke
plate (located on top plate at top of motor
housing) and set aside. Lift yoke plate and
top plate to remove from motor housing
and set aside.
WARNING: To reduce the risk of serious
bodily injury, DO NOT use power tools to
assemble the blades. If overtightened,
blades may crack and break.
Time Saver: Washers for blade screws can
be set on each blade screw prior to
installing blades.
Locate 15 blade attachment screws and
washers in a hardware pack. Slide blade
through one of the narrow, rectangular
openings on center band, aligning holes in
blade with holes in blade arm (located
inside motor housing). Insert 3 blade
attachment screws (along with washers)
with fingers first and then tighten screws
securely with a Phillips screwdriver. Repeat
procedure for each remaining blade.
Re-attach top plate and yoke plate to
yoke using washers and screws that
were previously removed. Be sure that
semicircular cutout on top plate and yoke
plate aligns over electrical wires for a proper
fit. (Also make sure that reverse switch aligns
properly with hole in top plate for reverse
switch--see drawing at right.) Tighten
screws to secure top plate and yoke plate.
["Fan Assembly" continued on next
page.]
NOTE: The important safety precautions and
instructions appearing in the manual are not
meant to cover all possible conditions and
situations that may occur. It must be
understood that common sense and caution
are necessary factors in the installation and
operation of this fan.
yoke
blade
arms
page 5
yoke plate
hole for reverse switch
top plate
blade attachment
screws and washers
center band
on motor
housing
reverse
switch
blade