Wiring - Craftmade Cronus Guia De Instalacion

6. Wiring.

Use a ballpoint pen or a small screwdriver to
set the code switches for the remote control
transmitter and remote control receiver so
that they match. Factory setting is pre-set
and not recommended for use. If your
remote control interferes with other
appliances, change to another matching
code on the remote control transmitter and
receiver.
In order for the remote control to operate,
one 9-volt battery (included in hardware
pack) should be installed in the remote
control transmitter. Remove battery cover.
After installing the battery, re-attach the
battery cover.
WARNING: Turn off circuit breakers to
current fixture from breaker panel and be
sure switch is turned to the OFF position.
CAUTION: Be sure outlet box is properly
grounded and that a ground wire (GREEN or
Bare) is present.
Make sure all electrical connections comply
with Local Codes or Ordinances and the
National Electrical Code. If you are unfamiliar
with electrical wiring or if the house/building
wires are different colors than those referred to
in the diagram to the right, please use a
qualified electrician.
NOTE: Excess lead wire length from the fan can
be cut to the desired length and then stripped.
When downrod is secured in place on the
hanging bracket, wire the RECEIVER with
wire connectors provided as shown in
diagram at right.
Tip: While you are wiring, keep in mind that
wires must not obstruct receiver from sliding
into hanging bracket.
* Wrap each wire connector separately with
electrical tape as an extra safety measure.
Gently insert receiver (switch side down)
into hanging bracket and carefully push
taped wire connectors into outlet box. Let
antenna rest outside of hanging bracket.
remote control
transmitter
9V
battery cover
Modifications not approved by the party responsible for compliance
could void the user's authority to operate the equipment.
*NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
* Reorient or relocate the receiving antenna.
* Increase the separation between the equipment and receiver.
* Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
white supply wire
black supply wire
blue
white
black
from fan
from receiver
black
white
blue
(wiring for receiver)
page 8
code switches
battery
remote
control
receiver
ground (green
or bare)
from ceiling
from receiver
black
AC IN L
white
AC IN N
receiver
antenna
radio
radio or television
ground (green
or bare)