Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

POWER REQUIREMENTS OF HEADPHONES
Charging rechargeable Ni-MH battery
The Ni-MH battery is
installed in the
headphones.
Charging output
terminal
1 Connect the AC adaptor to the transmitter and plug the AC adaptor into an AC
outlet.
2 Set the ON/OFF (power) switch on the headphones to OFF. The battery cannot be
charged when the switch is set to ON.
3 Set the headphones on the transmitter so that the Charging Input Terminal connects
to the Charging Output Terminal. Use both hands to set firmly.
4 The charger starts charging the battery automatically and the transmitter's indicator
lights in red. The indicator may not light in red if the headphones are not set properly.
In this case, adjust the position of the headphones until the indicator lights in red.
The battery can be fully charged in approx. 24 hours.
During recharge the indicator lights in red, which will start to blink rapidly near
completion. Blinking will gradually slow down or turn off at completion.
Note that depending on the condition of rechargeable battery or others, the
indicator may not blink even after recharging for 24 hours.
After charging is complete, you can use them continuously for approx. 35 hours.
Tips for better use
Be sure to charge the batteries within the temperature range of 50˚F ~ 95˚F
(10˚C ~ 35˚C).
Charging batteries that are not completely exhausted will cause efficiency to decline.
Be sure to charge them after they have been completely exhausted.
12
2
3
4
To DC IN 7.5V jack

Charging time

Battery running time
Charging input
terminal
To AC outlet
1

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido