Westfalia WT 487 Manual De Instrucciones página 15

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 28
TO STOP AND RESET THE ALARM TO COME ON THE NEXT DAY
When alarm 1 or 2 is sounding, the related alarm icon flashes. Press AL1-2 /ON-OFF once to stop
the alarm and reset it to come on the following day. After that both
on the display.
TO ACTIVATE THE SNOOZE FUNCTION (default snooze duration is 5 minutes)
When alarm is sounding, press
on again after the set snooze duration.
Note: if your second alarm activates while the first alarm is sounding or it is in the snooze mode, the
second alarm overrides the first alarm (the first alarm is reset to come on the next day).
TO SET UP THE FM ANTENNA
Extend the FM wire antenna fully and vary the direction for best FM reception. Do not strip, alter or
attach to other antennas.
TO LISTEN TO THE FM RADIO
To turn on the radio, press RADIO/SLEEP once, the display shows "ON" and then the radio
1.
frequency readings in Mhz.
2.
Press
or
the next clear station.
To adjust the volume, press VOL SET once, the display shows "L07", press
3.
adjust volume from L01 (minimum) to L16 (maximum) .
4.
Press RADIO/SLEEP to turn off the radio.
Note: keep your radio away from fluorescent lamps or other electronic devices, which may cause
interference to the radio.
TO STORE FM RADIO STATIONS IN MEMORY
This clock radio features a total of 20 preset memories of FM stations. These allow you to preset your
favorite stations and access them quickly.
1.
Press RADIO/SLEEP once to turn on the radio. Then tune to a FM radio station you like to
preset.
Press and hold the SET until "P01" flashes. Press SET once to store to "P01".
2.
3.
Press
or
Press and hold SET until "P02" flashes. Press
4.
once to store to "P02".
5.
Repeat Step 2 to 4 to store radio stations to P03 through P20.
6.
To remove a pre-stored station, repeat steps 2 to 4 to store another station in its place.
TO SELECT A PRESET RADIO STATION
When the radio is on, press SET once. Then press
TO SET THE SLEEP TIMER
When the radio is on, press and hold RADIO/SLEEP, the sleep time "05" (5 minutes) appears
1.
on the display.
2.
Press RADIO/SLEEP repeatedly to select a period (in minutes) from 05, 10, 15, 30, 45, 60, 75,
90 or OFF.
to tune the radio to a desired station. Press and hold
to select another station you like to preset (the radio frequency is displayed).
once, the alarm will be silenced momentarily and come
once to select 'P02", then press SET
or
repeatedly to select a preset station.
EN6
LED and/or
LED remain
or
to scan for
or
to

Publicidad

Tabla de contenido
loading

Tabla de contenido