Network Connection - Steren CCTV-971 Manual De Instrucciones

NETWORK CONNECTION

- The following instructions are only for reference. Look for how to open ports and
configure the modem with your Internet service provider (ISP).
- Consult a technician in case of not knowing how to connect a DVR to the Internet.
1. Connect the DVR to a LAN port
of the modem via a network cable.
2. To set an IP address, enter
the DVR Main Menu> System>
Network; options are the following:
Net Card
DHCP Enable: If you mark this
option, the modem automatically
assigns the address and ranges
in the IP address, Net Mask and
Gateway fields.
IP Address: To use this option you need to deselect the DHCP option, the IP address, Net
Mask and the gateway must be assigned manually. Remember, these parameters must be
within the modem range.
3. It is recommended to leave the factory settings in the Media and HTTP Port (which
establishes communication with the modem; however, you can assign a special range.
These same ports must be open on the modem to monitor the DVR locally and remotely.
21 21