Erreka RADSECTX Manual De Instalación página 10

5. Learning
5.1 Learning of the RADSECTX transmitters on the first relay of the RADSECRX receiver.
Check that the DIP 3 and 4 of the RADSECTX
1
transmitter and of the RADSECRX receiver are
set in the same way.
Press and keep pressed the key
2
present on the RADSECRX receiver.
Release the key on the RADSECRX
3
receiver.
Press and keep pressed the key
4
present on the RADSECTX transmitter.
Release the key of the transmitter
5
For the successive learning, repeat the operation from point 1.
5.2 Learning of the RADSECTX transmitter on the second relay of the RADSECRX receiver
Check that the DIP 3 and 4 of the RADSECTX
transmitter and of the RADSECRX receiver are
1
set in the same way.
Press and keep pressed the key
2
present on the RADSECRX receiver.
DO NOT release the key on the
3
RADSECRX receiver.
Release the key on the RADSECRX
4
receiver.
Press and keep pressed the key
5
present on the RADSECTX transmitter.
6 Release the key of the transmitter
NOTE: in case in which instead 4 BIP are reproduced, it means that the maximum number of transmitters for the selected channel has been
reached and that no new devices on the same relay can be memorized.
In case in which a device previously memorized is then associated to the other relay, it will be automatically removed from the previous relay.
For example, if a device memorized on the relay 1 is memorized on the relay 2 it will be automatically removed from the relay 1.
5.3 Summary of the acoustic signalling during the learning phase
6. Selection of the type of signal on output relay
Beside the two RADSECRX receiver relays a jumper for the selection of the type signal to give on output is present. This signal can be:
1. A clean contact : open contact in case of alarm and close if the alarm is not present
2. A contact type 8K2 : resistance of the contact = 0 or ∞ (Open loop) Ohm in case of alarm and 8K2 if the alarm is not present. The control unit
connected to the device must be able to handle this type of signal.
The selection of the type of signal is carried out in the following way:
MEC.
6-1620148 REV.2 25/10/2019
Acoustic signalling during the learning phase
Number of BIP
2 Transmitter correctly memorized
4 Mistake : the maximum number of transmitter for
selected channel has been reached
1 Maximum time up for the memorization of the
transmitter (10 second)
8K2
Jumper Pos. 1 Jumper Pos. 2
The RADSECRX receiver
emits ONE bip
The RADSECRX receiver emits
The learning has had a successful conclusion.
The RADSECRX receiver
emits ONE bip
The RADSECRX receiver
emits TWO bip.
The RADSECRX receiver emits TWO bip.
The learning has had a successful conclusion
Meaning
Position 1 : clean contact functioning (Mec)
Position 2 : 8K2 functioning (8K2)
ITA ENG FRA ESP DEU POR
10 / 28