Replacing Parts - Angelo Po 191BR2EA Manual De Uso E Instalación

RECOMMENDATIONS FOR REPLACING PARTS
Before carrying out any replacement procedure, ac-
tivate all the safety devices provided and decide
whether staff at work and those in the vicinity
should be informed. In particular, turn off the water
supply tap, cut off the electricity supply using the
master switch and prevent access to all devices
that might cause unexpected health and safety haz-
ards if turned on. If worn parts have to be replaced,
REPLACING THE WELL TILTING DEVICE
To carry out this operation, proceed as follows.
1 - Turn off the gas supply
tap.
2 - Undo the screws (A)
and remove the control
panel (B).
3 - Unscrew the screw (C).
4 - Undo the screws (D) to remove the support (E).
5 - Extract the gear motor and its components.
6 - If necessary, replace the gear motor (F), the
support (G), the gasket (H), the rotation stop
device (L) and the bearing (M).

REPLACING PARTS

B
A
- 25 -
use original spare parts only. The manufacturer de-
clines all responsibly for injury or damage to com-
ponents due to the use of non original parts, or
extraordinary work on the appliance which may
modify the safety requirements without the manu-
facturer's authorisation. When ordering compo-
nents, follow the instructions provided in the parts
catalogue.
B A
F H L G
M
C
IDM-39616701000.tif
D E
IDM-39616201900.tif
English
9
IT
GB
DE
FR
ES